This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
iw31:iw31:notes [2012/06/16 08:11] ben created |
iw31:iw31:notes [2013/04/22 06:07] (current) ben [Polyester Dye] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Odd-ball notes ====== | ====== Odd-ball notes ====== | ||
| + | |||
| + | ===== Polyester Dye ===== | ||
| + | |||
| + | * need to keep the fabric off the bottom of the pan, flat spots may have formed (found a small grate that will work for this) | ||
| + | * need to weigh the fabric down so steam bubbles don't form lifting the fabric out of the dye (have a basket with weights that will work) | ||
| + | * need to be above 100C for an extended period, ~45 minutes minimum | ||
| + | * streaking seems to be limited to one side- turning cushion forms inside out might give a better result | ||
| + | * first batch was small cushion, 50ml dye to 2L water, hue looks good aside from the streaking, trying a machine wash to see if the streaks go away | ||
| + | * 2nd go on the first cushion added 4L water but no dye (so original 50ml plus whatever went into the fabric in the first round) | ||
| + | * turned cushion inside out | ||
| + | * basket to keep fabric off the bottom in place, weighted basket above in place | ||
| + | * started cold at 10:10 | ||
| + | * reduced heat to 7 at 11 & stirred/shifted | ||
| + | * lid should not seal perfectly- that seems to stop steam bubbles from forming | ||
| + | * open and close vent periodically to prevent auto-shut-off from happening | ||
| + | * pulled and rinsed in cold water at 11:45 | ||
| + | ===== Other ===== | ||
| + | |||
| volvo instrument panel parts: | volvo instrument panel parts: | ||