This is an old revision of the document!
Misc Info
Hatch dimensions: 89 x 66cm
Motor mount dimensions: 20 x 23cm, 3×1/2“ ply
Toe rail: 5.2m
Tiller: 57cm + rise of 10cm
Barber haul cleat wood bases: 7 x 3.5cm
To-Do
Engine/Systems
Mast
New Windexneed to bend indicators back into place
Replace masthead lamp with LED
Install baton to lift backstay over sail headboard when tacking?Need a bigger/stronger baton
Forestay- rubs against jib halyard sheave, move it outside of the sheave position or remember to keep backstay loose (Found a suitable piece of steel to use to move the stay forward a centimeter or two)Sheave was in great shape, this isn't necessary
Replace lower boom kicker bracket (maybe upper too?) with something more sturdyBent back into shape, re-riveted
Sails/Rigging
Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat
Re-install washers on jib halyard block
New sail cover
Hull
Sand and varnish tiller, needs two more coats
Replace toe-rails or patch broken toe-rail section
Replace or refinish hatch-cover
Install external hatch handle
Replace wood underneath spinnaker barber-haul cleats
Patch random small cracks on deck & in cockpit
Cabin
Remove old log and fill holes
Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).Bolted down.
File pantry and stove cover doors down to allow for expansion
Re-attach trim to various panels
Floor board reinforce forward port side
Paint inside walls near cabin entrance
Sand and varnish walls underneath added deck supports (varnish is peeling)
Long-term
Safety lines - or at least a bow pulpit
Lazy jacks?
Window replacement
Find replacement mast support pole? Need to prime the top section of the pole, a bit of rust.
Replace motor mount plywood
Completed
Hull
Mast
Bottom painting supplies