This is an old revision of the document!
Bottom painting supplies
Misc Info
Hatch dimensions: 89 x 66cm
Motor mount dimensions: 20 x 23cm, 3×1/2“ ply
Toe rail: 5.2m
Tiller: 57cm + rise of 10cm
Barber haul cleat wood bases: 7 x 3.5cm
To-Do
Engine/Systems
Install security bolts
Replace motor mount plywood
Depth sounder is dead- repair
motor mount, sliding up, could be lowered a bit?
replace starter battery with storage battery
Mast
Remove lost/dropped halyard blocks from center of mast DONE!
Either get 12-20 screws for spreaders or drill out to MM size Drilled and tapped to M6!
Replace masthead lamp with LED
Install baton to lift backstay over sail headboard when tacking?
Forestay- rubs against jib halyard sheave, move it outside of the sheave position or remember to keep backstay loose (Found a suitable piece of steel to use to move the stay forward a centimeter or two)
Replace lower boom kicker bracket (maybe upper too?) with something more sturdy
Sails/Rigging
Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat
Re-install washers on jib halyard block
New sail cover
Hull
Patch small paint crack just above water line on starboard side near stern
Replace toe-rails
Replace hatch-cover
Install external hatch handle
Replace wood underneath spinnaker barber-haul cleats
Check rudder bearings and shaft condition Should be okay for a long time to come.
Bottom
Reattach (replace?) cockpit floorboards
Sand and varnish tiller, needs two more coats
Patch random cracks on deck & in cockpit
Cabin
Remove old log and fill holes
Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).
File pantry and stove cover doors down to allow for expansion
Re-attach trim to various panels
Floor board reinforce forward port side - completely rebuilding the forward floor boards, will take several gluing sessions and new screws.
Paint inside walls near cabin entrance
Sand and varnish walls underneath added deck supports (varnish is peeling)
Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better)
Long-term
Safety lines - or at least a bow pulpit
Lazy jacks?
Window replacement
Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust.
Completed