rini:to-do_2011
This is an old revision of the document!
Table of Contents
Bottom painting supplies
- masks
- gloves
- scrapers
- containers to mix epoxy paint (that won't melt, tin cans maybe)
Misc Info
- Hatch dimensions: 89 x 66cm
- Motor mount dimensions: 20 x 23cm, 3×1/2“ ply
- Toe rail: 5.2m
- Tiller: 57cm + rise of 10cm
- Barber haul cleat wood bases: 7 x 3.5cm
To-Do
Long-term
- Safety lines - or at least a bow pulpit
- Lazy jacks?
- Window replacement
- Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust.
Engine/Systems
- Install security bolts
- Replace motor mount plywood
- Depth sounder is dead- repair
- motor mount, sliding up, could be lowered a bit?
- replace starter battery with storage battery
Mast
- Remove lost/dropped halyard blocks from center of mast
- Either get 12-20 screws for spreaders or drill out to MM size
- Replace masthead lamp with LED
- Install baton to lift backstay over sail headboard when tacking?
Sails/Rigging
- Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat
- Forestay- rubs against jib halyard bearing, move it outside of the bearing position or remember to keep backstay loose
- Re-install washers on jib halyard block
- New sail cover
Hull
- Patch small paint crack just above water line on starboard side near stern
- Replace toe-rails
- Replace hatch-cover
- Install external hatch handle
- Replace wood underneath spinnaker barber-haul cleats
- Check rudder bearings and shaft condition
- Bottom
- Reattach (replace?) cockpit floorboards
- Sand and varnish tiller
Cabin
- Remove old log and fill holes
- Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).
- File pantry and stove cover doors down to allow for expansion
- Re-attach trim to various panels
- Floor board reinforce forward port side - completely rebuilding the forward floor boards, will take several gluing sessions and new screws.
- Paint inside walls near cabin entrance
- Sand and varnish walls underneath added deck supports (varnish is peeling)
- Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better)
Completed
rini/to-do_2011.1300180845.txt.gz · Last modified: 2011/03/15 05:20 by ben
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
