This is an old revision of the document!
Halyard Winch
Halyard winch is held together not by the single top mounted flat-head screw, but by a C-clip that the screw and cap cover. To service the winch:
Remove the top screw and cap.
Carefully place a length of duct tape on the C-clip to prevent it from flying away.
Gently pry the C-clip off with a small flat head screw driver.
Slide winch elements off shaft- careful not to lose an internal washer.
Rear Winches
Rear winches are held together by a single top flat-head screw.