..., etc.

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

==== Misc Info ====

  * Hatch dimensions: 89 x 66cm
  * Motor mount dimensions: 20 x 23cm, 3x1/2" ply
  * Toe rail: 5.2m
  * Tiller: 57cm + rise of 10cm
  * Barber haul cleat wood bases: 7 x 3.5cm

==== To-Do ====

=== Long-term ===
  * Safety lines - or at least a bow pulpit
  * Lazy jacks?
  * Window replacement
  * Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust. 


=== Engine/Systems ===
  * Install security bolts
  * Replace motor mount plywood
  * Depth sounder is dead- repair
  * motor mount, sliding up, could be lowered a bit?
  * replace starter battery with storage battery

=== Mast ===

  * Remove lost/dropped halyard blocks from center of mast
  * Either get 12-20 screws for spreaders or drill out to MM size
  * Replace masthead lamp with LED
  * Install baton to lift backstay over sail headboard when tacking?

=== Sails/Rigging ===

  * Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat
  * Forestay- rubs against jib halyard bearing, move it outside of the bearing position or remember to keep backstay loose
  * Re-install washers on jib halyard block
  * **New sail cover**

=== Hull ===

  * Patch small paint crack just above water line on starboard side near stern
  * Replace toe-rails
  * Replace hatch-cover
  * Install external hatch handle
  * Replace wood underneath spinnaker barber-haul cleats
  * Check rudder bearings and shaft condition
  * Bottom
  * Reattach (replace?) cockpit floorboards
  * Sand and varnish tiller

=== Cabin ===

  * Remove old log and fill holes
  * Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).
  * File pantry and stove cover doors down to allow for expansion
  * Re-attach trim to various panels
  * Floor board reinforce forward port side - completely rebuilding the forward floor boards, will take several gluing sessions and new screws.  
  * Paint inside walls near cabin entrance
  * Sand and varnish walls underneath added deck supports (varnish is peeling)
  * Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better)

==== Completed ====
..., etc.

User Tools

Site Tools

Page Tools
