Differences

This shows you the differences between two versions of the page.

--- mspacman:mspacman [2011/02/11 08:52]
ben [Gallery]
+++ mspacman:mspacman [2013/09/30 06:07]
ben
@@ Line 79: / Line 79: @@
 {{gallery>:mspacman:gallery?lightbox}}
+====== Pi ======
+<code>
+pi@pi ~ $ cat /boot/config.txt
+# uncomment if you get no picture on HDMI for a default "safe" mode
+#hdmi_safe=1
+# uncomment this if your display has a black border of unused pixels visible
+# and your display can output without overscan
+#disable_overscan=1
+# uncomment the following to adjust overscan. Use positive numbers if console
+# goes off screen, and negative if there is too much border
+#overscan_left=16
+#overscan_right=16
+#overscan_top=16
+#overscan_bottom=16
+# uncomment to force a console size. By default it will be display's size minus
+# overscan.
+#framebuffer_width=1280
+#framebuffer_height=1024
+#framebuffer_height=720
+# uncomment if hdmi display is not detected and composite is being output
+#hdmi_force_hotplug=1
+# uncomment to force a specific HDMI mode (this will force VGA)
+hdmi_group=2
+hdmi_mode=35
+# uncomment to force a HDMI mode rather than DVI. This can make audio work in
+# DMT (computer monitor) modes
+#hdmi_drive=2
+# uncomment to increase signal to HDMI, if you have interference, blanking, or
+# no display
+config_hdmi_boost=4
+# uncomment for composite PAL
+#sdtv_mode=2
+#uncomment to overclock the arm. 700 MHz is the default.
+#arm_freq=800
+# for more options see http://elinux.org/RPi_config.txt
+gpu_mem=16
+</code>
+Unfortunately get a blank screen when trying to run Mame.  Found [[http://tech.enekochan.com/2013/05/28/fix-black-screen-in-raspberry-pi-with-hdmi-to-vga-adapter/|this link which includes]]:
+<code>
+disable_overscan=1
+hdmi_group=2
+hdmi_mode=35
+hdmi_drive=2
+</code>
+Latest problem is the PiMame distro (and the one from the Pi store) are too old a version to support mspacman.  Really need to find a way to get SDL mame going...

..., etc.

User Tools

Site Tools

Differences

Page Tools