rini:to-do

Safety lines - or at least a bow pulpit
Window replacement
Find replacement mast support pole? Need to prime the top section of the pole, a bit of rust.
Replace motor mount plywood

~~Weld tiller bracket back together~~
~~Patch small paint crack just above water line on starboard side near stern~~
~~Check rudder bearings and shaft condition~~ Should be okay for a long time to come.
~~Bottom paint~~

~~Remove lost/dropped halyard blocks from center of mast~~ DONE!
~~Either get 12-20 screws for spreaders or drill out to MM size~~ Drilled and tapped to M6!
~~New Windex~~
~~Replace masthead lamp with LED~~
~~Install baton to lift backstay over sail headboard when tacking?~~
Forestay- rubs against jib halyard sheave, move it outside of the sheave position or remember to keep backstay loose (Found a suitable piece of steel to use to move the stay forward a centimeter or two)Sheave was in great shape, this isn't necessary
~~Replace lower boom kicker bracket (maybe upper too?) with something more sturdy~~Bent back into shape, re-riveted

~~Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat~~
~~Re-install washers on jib halyard block~~

~~Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).~~Bolted down.