skip to content

..., etc.

User Tools

Log In

Site Tools

Recent Changes
Media Manager
Sitemap

Trace:

rini:winch_notes

===== Halyard Winch =====

Halyard winch is held together not by the single top mounted flat-head screw, but by a C-clip that the screw and cap cover.  To service the winch:

  * Remove the top screw and cap.  
  * Carefully place a length of duct tape on the C-clip to prevent it from flying away.
  * Gently pry the C-clip off with a small flat head screw driver.
  * Slide winch elements off shaft- careful not to lose an internal washer.
===== Rear Winches =====

Rear winches are held together by a single top flat-head screw.

Port side winch is held to the mount by 4 flat head counter-sunk screws.

Starboard side winch is held to the mount by 1 counter sunk flat head screws and 3 counter sunk socket head cap screws (Allen wrench screws).

rini/winch_notes.1240128168.txt.gz · Last modified: 2009/04/19 04:02 by ben

Page Tools

Show page
Old revisions
Backlinks
Back to top

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported

CC Attribution-Noncommercial-Share Alike 3.0 Unported