..., etc.


==== Bottom painting supplies ====

  * <del>masks</del>
  * <del>gloves</del>
  * <del>scrapers</del>
  * <del>masking tape</del>
  * <del>drop cloths</del>
  * <del>containers to mix epoxy paint (that won't melt, tin cans maybe)</del>
  * <del>sand paper</del>
  * <del>sanding blocks</del>
  * <del>beer</del>
  * <del>bourbon</del>
==== Misc Info ====

  * Hatch dimensions: 89 x 66cm
  * Motor mount dimensions: 20 x 23cm, 3x1/2" ply
  * Toe rail: 5.2m
  * Tiller: 57cm + rise of 10cm
  * Barber haul cleat wood bases: 7 x 3.5cm

==== To-Do ====

=== Engine/Systems ===
  * Install security bolts
  * Replace motor mount plywood
  * Depth sounder is dead- repair
  * motor mount, sliding up, could be lowered a bit?
  * replace starter battery with storage battery

=== Mast ===

  * <del>Remove lost/dropped halyard blocks from center of mast</del> DONE!
  * <del>Either get 12-20 screws for spreaders or drill out to MM size</del> Drilled and tapped to M6!
  * Replace masthead lamp with LED
  * Install baton to lift backstay over sail headboard when tacking?
  * Forestay- rubs against jib halyard sheave, move it outside of the sheave position or remember to keep backstay loose (Found a suitable piece of steel to use to move the stay forward a centimeter or two)
  * Replace lower boom kicker bracket (maybe upper too?) with something more sturdy

=== Sails/Rigging ===

  * Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat
  * <del>Re-install washers on jib halyard block</del>
  * **New sail cover**

=== Hull ===

  * <del>Sand and</del> varnish tiller, needs two more coats 
  * Replace toe-rails
  * Replace hatch-cover
  * Install external hatch handle
  * Replace wood underneath spinnaker barber-haul cleats
  * Reattach (replace?) cockpit floorboards
  * Patch random cracks on deck & in cockpit

=== Cabin ===

  * Remove old log and fill holes
  * Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).
  * File pantry and stove cover doors down to allow for expansion
  * Re-attach trim to various panels
  * Floor board reinforce forward port side - completely rebuilding the forward floor boards, will take several gluing sessions and new screws.  
  * Paint inside walls near cabin entrance
  * Sand and varnish walls underneath added deck supports (varnish is peeling)
  * Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better)

=== Long-term ===
  * Safety lines - or at least a bow pulpit
  * Lazy jacks?
  * Window replacement
  * Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust. 

==== Completed ====
  * Weld tiller bracket back together

=== Hull ===

  * <del>Patch small paint crack just above water line on starboard side near stern</del>
  * <del>Check rudder bearings and shaft condition</del> Should be okay for a long time to come.
  * <del>Bottom paint</del>
..., etc.

User Tools

Site Tools

Page Tools
