This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
mspacman:mspacman [2011/02/11 08:52] ben [Gallery] |
mspacman:mspacman [2013/09/26 13:03] ben |
||
---|---|---|---|
Line 79: | Line 79: | ||
{{gallery>:mspacman:gallery?lightbox}} | {{gallery>:mspacman:gallery?lightbox}} | ||
+ | |||
+ | ====== Pi ====== | ||
+ | <code> | ||
+ | pi@pi ~ $ cat /boot/config.txt | ||
+ | # uncomment if you get no picture on HDMI for a default "safe" mode | ||
+ | #hdmi_safe=1 | ||
+ | |||
+ | # uncomment this if your display has a black border of unused pixels visible | ||
+ | # and your display can output without overscan | ||
+ | #disable_overscan=1 | ||
+ | |||
+ | # uncomment the following to adjust overscan. Use positive numbers if console | ||
+ | # goes off screen, and negative if there is too much border | ||
+ | #overscan_left=16 | ||
+ | #overscan_right=16 | ||
+ | #overscan_top=16 | ||
+ | #overscan_bottom=16 | ||
+ | |||
+ | # uncomment to force a console size. By default it will be display's size minus | ||
+ | # overscan. | ||
+ | #framebuffer_width=1280 | ||
+ | #framebuffer_height=1024 | ||
+ | #framebuffer_height=720 | ||
+ | |||
+ | # uncomment if hdmi display is not detected and composite is being output | ||
+ | #hdmi_force_hotplug=1 | ||
+ | |||
+ | # uncomment to force a specific HDMI mode (this will force VGA) | ||
+ | hdmi_group=2 | ||
+ | hdmi_mode=35 | ||
+ | |||
+ | |||
+ | # uncomment to force a HDMI mode rather than DVI. This can make audio work in | ||
+ | # DMT (computer monitor) modes | ||
+ | #hdmi_drive=2 | ||
+ | |||
+ | # uncomment to increase signal to HDMI, if you have interference, blanking, or | ||
+ | # no display | ||
+ | config_hdmi_boost=4 | ||
+ | |||
+ | # uncomment for composite PAL | ||
+ | #sdtv_mode=2 | ||
+ | |||
+ | #uncomment to overclock the arm. 700 MHz is the default. | ||
+ | #arm_freq=800 | ||
+ | |||
+ | # for more options see http://elinux.org/RPi_config.txt | ||
+ | gpu_mem=16 | ||
+ | </code> | ||
+ | |||
+ | Unfortunately get a blank screen when trying to run Mame. Found [[http://tech.enekochan.com/2013/05/28/fix-black-screen-in-raspberry-pi-with-hdmi-to-vga-adapter/|this link which includes]]: | ||
+ | <code> | ||
+ | disable_overscan=1 | ||
+ | hdmi_group=2 | ||
+ | hdmi_mode=35 | ||
+ | hdmi_drive=2 | ||
+ | </code> |